Sawing According To Tracings; Service And Maintenance; Storage - Mafell MS 55 Traducción Del Manual De Instrucciones Original


Unfasten the wing screw 1 (Fig. 1).

Adjust the angle according to the scale on the
segment for tilting.

Afterwards, tighten the wing screw 1.

5.5 Sawing according to tracings

The base plate has three tracing edges 10 (Fig. 2) for
0°, 30° and 45°. These tracing edges correspond to
the saw blade's inside. For bevel cuts, the tracing can
be viewed through the opening on the left-hand side
of the upper saw guard.

Hold the machine by its handles and place the
front part of its base plate onto the workpiece.

Switch on the portable circular saw (see chapter
5.2) and slide the machine evenly forward in the
direction of the cut.

When the cut is completed, switch off the saw
by releasing the switch trigger 13 (Fig. 3).
6

Service and maintenance

Danger
Pull the power plug during all
service work.
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.

6.1 Storage

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
-22-