Thermal Protection - Cebora MIG 2035/M Manual De Instrucciones

IP23 C. Protection rating for the housing.
Grade 3 as the second digit means that this
equipment is suitable for use outdoors in the
rain.The additional letter C means that the
equipment is protected against access to
the live parts of the power circuit by a tool
(diameter 2.5 mm ).
S
Suitable for use in high-risk environments.
NOTE: The welding machine has also been designed for
use in environments with a pollution rating of 3. (See IEC
664).
2.3 PROTECTIONS
2.3.1 Block protection
In the event of a malfunction, a number with the following
meaning may appear on the display G:
52 = Start button pressed during start-up.
53 = start button pressed during thermostat reset.
56 = Extended short-circuit between the welding
electrode and the material to be welded.
Shut the machine off and turn it back on.
If different numbers appear on the display, contact tech-
nical service.
A
B
C
D
E
F
10
®
INVERTER
MIG
MIG 2035 / M MIG 2035 / M
PULSE PULSE PULSE
285
Art.
2.3.2 Mechanical protection (safety button)
When the movable side is opened, this activates the safe-
ty button which prevents operation of the welding
machine. This protection, indicated when the flashing
message "OPn" appears on display G, avoids hazardous
situations when the operator replaces the roller of the
wire feeder unit or the welding electrode.

2.3.3 Thermal protection

This machine is protected by a thermostat, which prevents
the machine from operating if the allowable temperatures are
exceeded. In these conditions the fan continues to operate
and the display G flashes the abbreviation "OPn".
3 INSTALLATION
Make sure that the supply voltage matches the voltage
indicated on the specifications plate of the welding
machine.
Mount a plug with an adequate capacity for the supply
cable, making sure that the yellow/green conductor is
connected to the earth pin.
The capacity of the overload cutout switch or fuses
installed in series with the power supply must be equiva-
lent to the absorbed current I1 of the machine.
888
HOLD
SINERGIC
A
5 6 5
4 7 4
3 8 3
2 2
9
1 1
10
V
5 6 5
4 7 4
3 8 3
2 9 2
1 10 1
0
88
1
2
3
4
5
P
3.1 START-UP
MIG
PULSE
6
7
8
9
10
6
7
8
9
10
1
2
3
4
5
G
H
I
L
M
N
O
P
Q
R
S
Fig. 1