Zoeller Basement Sentry STBS700 Manual De Instrucciones página 4

CONNECTING THE STBS700 PUMP TO THE CONTROLLER
By connecting the STBS700 pump to the Basement Sentry app
using the built-in WIFI, the user can set up free alert messages
via email and mobile app "push" notifications. In addition, the user
can verify the STBS700 pump readiness, remotely silence alarms,
reset the unit, configure settings, and modify how notifications are
sent. Other visual information such as pump status are available
through the web and app interfaces.
Before you begin:
• Download the Z Control® App, set up account, or go to
zcontrolcloud.com and create account.
• Know your WIFI network's name (SSID) and the password.
Double check that you know the correct password and exactly
how it is spelled, including capitalization. This will prevent the
most common troubleshooting issue.
• Verify your WIFI router is connected to the internet.
• Verify your phone, tablet, or computer has working WIFI, can
connect to your WIFI router, and that you can be close to the
STBS700 pump during the installation process.
• Locate and note the STBS700 pump Device ID on the silver
sticker on the back of the pump.
Option 1 - Use the Mobile App (iOS and Android)
Before you begin:
• Know what the WiFi router is named (i.e. SSID) and
password. To prevent the most common troubleshooting
issues, double check to be sure you know exactly how the
password is spelled, including capitalization.
• Verify that your mobile device has working WiFi with a strong
signal when you are standing next to the Basement Sentry
controller. If the signal is questionable, the controller may not
be able to maintain a stable connection.
• Verify your WiFi router is connected to the internet and that it
is broadcasting a visible, secure, 2.4Ghz network.
• 2.4 Ghz network is required. If you only see 5 Ghz networks,
you may need to log into your dual band router to choose to
broadcast the networks separately.
• Band steering may need to be temporarily turned off during
setup.
• The 2.4Ghz network must use WPA or WPA2 security. WEP
and open networks are not acceptable.
• Any VPNs or other network controls may need to be
temporarily turned off during setup.
• Locate the Basement Sentry Device ID located on the bottom
of the controller.
• Like most internet connected devices, the Basement Sentry
controller WiFi connectivity should be used behind the security
of a firewall. Most routers have a firewall built into them.
Consult a networking professional for specific questions about
firewalls.
NOTE: The list above will also help troubleshoot connectivity
issues.
4
© 2020. All rights reserved.
1
Green Power LED
Red Alarm LED
This LED should be off
when STBS700 pump is
in AP mode.
When user is connected 252mm
to STBS700 pump to set
up WIFI, LED will blink.
When STBS700 pump is
connected to router and
the Basement Sentry
app, this LED will be
solid.
Silence / Reset / Link Button
POWER
ALARM
SILENCE
Reset:
Press for 3 seconds
B Y
INTELLIGENT
SUMP
CONNECTS TO
MOBILE
DEVICES
SW1590 A