Zoeller Basement Sentry STBS700 Manual De Instrucciones página 7

CONNECTING THE STBS700 PUMP TO THE CONTROLLER (CONTINUED)
Use the Mobile App (iOS and Android) (Continued)
6. When the captive screen opens, use the WiFi Scan button to find
the WiFi network you want the controller to use, select it from the
list provided at the bottom of the screen (you may need to scroll),
and type the password in the field. The Z Control
solid within a minute indicating successful connection to the router
and the Z Control Cloud. Upon first connecting to the cloud, the
®
Basement Sentry controller may immediately update its firmware
over-the-air (OTA), if an update is available. If an update is taking
place, the Z Control LED will flicker for up to one minute while
®
the update is downloaded. The Z Control
all other LEDs will turn off while the update is being installed. After
up to one minute, the controller will restart and return to normal
operation. The controller alert history on the Z Control
also be updated with the firmware update information, and any
email accounts that are set up will be notified.
7. You can now return to the Z Control
device set up in the location you previously selected. You can
always change a device to a different location in your account.
8. Open the Basement Sentry app to explore current status,
configuration settings, and commands available, such as
Pump Test, Buzzer Test, Silence, etc. Perform these test to be
sure everything works as expected. Reset all alarms when you
are finished.
LED should be
®
LED will be solid and
®
Cloud will
®
app to find your new
®
7
© 2020. All rights reserved.
6
Click WiFi
Scan button
7
8