Sirius S901 Instrucciones De Uso Y De Montaje página 10

MAINTENANCE
- An accurate maintenance guarantees good
functioning and long-lasting performance.
- Particular care is due to the grease filter pa-
nel. It can be removed by pushing its special
handle toward the back-side of the cooker
hood and turning the filter downwards so to
unfasten it from its slot (Fig.3).
To insert the filter just perform the opposite
operation.
After 30 hours working, the push button
control panel will signal the saturation of the
grease filter by lighting all the buttons. Press
the timer button to reset
The grease filter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
- In case the appliance is used in its filtering
version, the active coal filter (Fig.7) needs to
be periodically replaced. The coal filter can
be removed by removing the grease filter
first (Fig.3), and by pulling its special plastic
tongue until it is unfastened from its slot.
Re-insert the coal filter by operating in the
opposite way.
The coal filter needs replacing depending on
the use, but however every six months at le-
ast.
- How to remove the oil tank. After having
removed the grease filters and eventually the
active coal filters, please hold the oil tank up
by one hand and ioosen the three handles by
the other hand as showed in fig.8. Then let
the tank slide downwards making attention in
order to avoid the leak of oil.
- To clean the appliance itself tepid water and
neutral detergent are recommended, whi-
le abrasive products should be avoided. For
steel appliances specialized detergents are
recommended (please follow the instructions
indicated o the product itself to obtain the
desired results).
- Warning! To take down the appliance from
the cabinet, remove the definitive fixing
screws (fig. 6) using a screw-driver, get off
the grease filters (fig.3) and the active carbon
filters, if they are inserted (fig. 7).
.
11
Act on the small handle of the springs, which
are inside the built-in unit, with the neces-
sary strength to unhook the appliance from
the cabinet.
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualified person in order
to avoid a hazard.
To replace the dichroic lamp, remove the
lamp (fig.9) by inserting a screwdriver or
another sharp too between the lamp and its
chrom support and replace it with a l'appareil
lamp of the same kind.
Substitution of the LED bar:
Using an appropriate tool, remove the LED
bar from its seat (refer to Fig. 11), disconnect
it electronically using the appropriate con-
nector then substitute it with a LED bar with
same characteristics.