Sirius S901 Instrucciones De Uso Y De Montaje página 9

Essential precautions to respect before in-
stalling the appliance are the following:
To have made a cut-out on the bottom of the
cabinet which is suitable to hold the applian-
ce in position (fig.4 for S901, fig. 4A for S902,
S906, S906L).
- prepare the power supply.
- prepare a hole for the exhaust of the air
both in the filtering and in the exhauting ver-
sion.
To install the appliance, adjust the position
of the stop side-springs using the appropria-
te screws (fig.5), according to the thickness
of the board previously drilled, on which the
appliance will be fixed.
Insert the built-in unit in the hole made in the
cabinet until the stop click of the side- sprin-
gs is heard and the built-in unit is blocked.
Insert the screws provided in the holes inside
the appliance (fig.6) to block it completely.
Put the grease filter again
Blocking of the stop valve
Warning!
Before connecting the flexible exhausting
pipe to the motor, make sure the stop valve,
which is on the air outlet of the motor, can
swing.
Exausting version
Connect the flange to the exhausting hole
with an appropriate pipe. Connect the ap-
pliance with the electrical mains through the
supply cord.
Filtering version
Connect the flange with a pipe suitable to
convey the air to the top of the cabinet. Con-
nect the appliance with the electrical mains
through the supply cord.
Rear vented version
All the models SL906L with one motor can
be rear vented; if the customer wants to use
this option, it is necessary to remove the 18
screws from the motor group support. Then
take the metal support with motor included
out (pic. 12). Turn the motor to have the air
outlet on the rear side (pic. 13) and fix the
scews previously removed.
WORKING
Mod. S901-S902 (fig. 10)
A: Light switch on/off
B: Motor switch on speed 1/off
C: Motor switch on speed 2
D: Motor switch on speed 3
E: Motor switch on speed 4
F: 10-minutes timer
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the
European Commission, which came into force
as from January 1st, 2015 , our products have
been adapted to comply with these new re-
quirements.
All of the models complying with the energy
label requirements, are equipped with new
electronics including a timer device for suction
speeds control, when the air capacity exceeds
650m³/h.
Internal motor models, with maximum air
capacity higher than 650m³/h, are equipped
with a timer device that automatically switches
the suction speed from 4th to 3rd speed, after
5 minutes operation.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.
10