Guarantee Information - Be Cool BUBBLE Instrucciones

GB
INSTRUCTIONS FOR ASSEMBLY AND USE
Unfolding
1
1 Open the folding lock.
2 Lift the handle as shown, stroller unfolded.
Attention: Make front wheels and rear wheels parallel, or it will prevent unfolding smoothly.
Assembling the front handrail
2
1 Push the front handrail into the hole on the foot rest plastic, until the button is coming out from the bottom
button.
2 Press down the front handrail bottom button and pulled out to disassemble the handrail.
Applying the brakes
3
1 To engage the brakes: step down the rear part of brake pedal.
2 To release the brakes: step down the front part of the pedal.
Applying the reclining backrest
4
1 Push up the backrest directly to the position you want
2 Pull up the backrest trigger to adjust downwards to the position you want.
Assembling the buckle
5
1 To insert the left and right ends to the hole until the"click"sound and safety locked, as picture 1.
2 To press the middle of the button and unlocked, as picture 2.
Stroller folding
6
1 Push upwards the backrest position to the stand position firstly.
2 Furl the canopy as photo.
3 Press the two buttons situationed on the both sides of the handlebar as photo shown and push down the up-
per handlebar until it close to the down tube.
4 Close the stroller as shown with strength until you hear click (attention:make front wheels and rear wheels
parallel to avoid wheels conflict, affecting close of stroller).
Carrying
7
1 You could hold the bottom tube to carry the stroller as photo shown.
2 Also you could carry the stroller as photo shown.(if you need, you could put the stroller into the transporting
bag).
Car seat
8
1 Open the buttons on the side arm rest and insert the adaptors to the holes on the side arm rest until the
"click"sound as picture 1.
2 To remove the car seat: lift up the adaptor buttons on both sides and lift up the car seat body as picture 2.
ADJUST THE SEAT BELTS TO FIT THE CHILDREN WHENEVER THEY USE THE PUSHCHAIR
9
The two side fastening points of the seats can be used to attach an additional harness. Your pushchair is
approved for new born babies. To fit the belts on your baby when he is under 6 months old, pass the shoulder
straps through the lower holes and fasten the shoulder protector pads using the Velcro. When your child is
over 6 months old, pass the straps through the holes that are most comfortable for the child.
MAINTENANCE
-Wash the plastic parts in warm soapy water. Afterwards, carefully dry all the components.
-The cover can easily be removed for washing.
-Wash by hand and at a temperature never above 30ºC. Dry naturally in a shaded place.
-Prolonged exposure of the cover to sunlight may affect the stability of the fabric colour.

GUARANTEE INFORMATION

This article is guaranteed in accordance with R.D. 1/2007 of 16th November. Keep your receipt as proof of purchase,
you need to show it at the store where you purchased the product to prove validity in the event of any type of claim.
This guarantee does not cover any faults or breakages caused by misuse of the article or by not following the safety
and maintenance information listed in the instructions and on the care labels.
11