Invacare InTouch ITFG Manual Del Usuario página 4

Removing/Installing the cushion covers
Removing the outer cover
NOTE: For this procedure, refer to FIGURE 2.
The covers are designed to protect the foam from moisture and to provide fire retardency.
DO NOT use the cushion without either the inner or outer cover. If the covers are torn, they
MUST be replaced IMMEDIATELY.
1. Remove the cushion from the seating surface. Refer to Attaching/Removing the Cushion
To/From the Seating Surface on page 3.
2. Unzip the outer cover.
3. Remove cushion, still inside the inner cover, from the outer cover.
DO NOT remove both the outer cover and inner cover at the same time, otherwise damage
to the inner cover material may occur.
Installing the outer cover
NOTE: For this procedure, refer to FIGURE 2.
1. Position the cushion with inner cover and the pelvic support layer in place toward the rear of the
outer cover.
NOTE: The pelvic support layer is at the top of the inner cover.
NOTE: The zipper is at the rear and the stretch fabric is at the top of the outer cover.
2. Slide the cushion into the outer cover.
Use care not to snag the inner cover in the outer cover zipper, or damage to the inner cover
will occur.
3. Zip the outer cover closed.
4. Reattach cushion onto seating surface. Refer to Attaching/Removing the Cushion To/From the
Seating Surface on page 3.
FIGURE 2 Removing/Installing the cushion covers - Installing the outer cover
InTouch™ Flovair Cushion
Outer Cover
WARNING
CAUTION
CAUTION
Inner Cover
Zipper
4
Cushion
Part No 1141447