General Characteristics - Cembre TC050Y Manual De Uso Y Mantenimiento

1. GENERAL CHARACTERISTICS

– Application range: suitable for cutting copper, aluminium, aluminium steel reinforced cables
– Max operating pressure: .............................................................................................. 700 bar
– Oil necessary (displacement): ..................................................................................... 38 cm
– Dimensions: length ......................................................................................................... 331 mm (13 in.)
width .......................................................................................................... 112 mm (4.4 in.)
– Weight: ................................................................................................................................. 3,3 kg
2. INSTRUCTIONS FOR USE
2.1) Setting
(Ref. to Fig. 3)
The head is equipped with a "self-lock"quick male coupler suitable for connection to a hydraulic,
pneumatic or electric pump from the Cembre range.
Insert the conductor between the blades, up to the desired cutting point. For a running conductor,
release the latch (16) and open the tool head.
Fully retract the lower blade (07) before attempting to open the tool head.
With the conductor on the lower blade (07), close the tool head and fully secure the latch (16).
Before commencing the cutting operation ensure that the latch (16) is fully secured: partial closure
may damage the tool head.
2.2) Blade advancement
Operate the pump to advance the lower blade.
Make sure the blades are exactly positioned on the desired cutting point; otherwise re-open the
blades, as § 2.4 and re-position the cutting head.
2.3) Cutting
Continue operating the pump to close the blades and progressively cut the cable.
The tool is designed tor cutting copper, aluminium and ACSR cables. Do not attempt to cut
steel ropes guy wire and ground rod.
2.4) Blade opening
To open the blades, fully discharge the oil pressure from the pump.
3
HYDRAULIC CUTTING HEAD
(ACSR) having a max ø of .......................................................50 mm
TC050Y
ENGLISH
(2 inches)
(10,000 psi)
3 (2.3 cu. in.)
(7,3 lbs)