General Characteristics - Cembre HT-TC051Y Manual De Uso

• Wear eye protection. Metal chips can fly from blades when cutting.
• Do not cut short, free pieces of steel reinforced cables (ACSR) as they may fly off dangerously,
causing injury to the operator or persons nearby.
• Inspect the blades before each use. Do not use damaged blades.
• Damaged blades can break and cause injury or damage to the tool.
• Work in a clean, uncluttered area. Keep persons away from immediate work area.
• Use this cutting tool for the manufacturer's intended purpose only.
• Do not cut live cables or conductors.

1. GENERAL CHARACTERISTICS

– Application range: suitable for cutting copper, aluminium, aluminium steel reinforced cables
(ACSR) having a max ø of ............................................................................................... 50 mm
– Rated operating pressure: ........................................................................................... 700 bar (10,000 psi)
– Dimensions: length ............................................................................................. ........... 503 mm (19.8 in.)
width 129 mm ........................................................................................ (5.1 in.)
– Weight: ................................................................................................................................. 4,7 kg
– Oil: .......................................................................................AGIP ARNICA 32
– Advancing speed: the tool automatically switches from a fast advancing speed of blades to a
slower cutting speed.
– Safety: the tool is provided with max pressure valve; MPC1 special manometer, is available upon
request to check the proper setting of the valve.
2. INSTRUCTIONS FOR USE
2.1) Setting
Insert the cable between the blades at the desired cutting point.
For a running cable, press latch (28) and open the upper blade assembly.
Warning: the opening of upper blade assembly must be done when the tool is in rest position, with
the lower blade (18) completely retracted.
With the cable on the lower blade (18), close the upper blade assembly and secure the latch (28).
3
HYDRAULIC CUTTING TOOL
HT-TC051Y
WARNING
(Ref. to Fig. 1)
SHELL TELLUS TX 32
ENGLISH
(2 in.)
(10.3 lbs)
or
or equivalent