Maintenance And Care - AL-KO TECH 120 OHV Manual De Instrucciones

Keep combustible materials away from exhaust and
„
cylinder.
Let exhaust, cylinder and cooling fins cool off before
„
touching.
Storage
Attention!
Do not store engine in front of naked flames or heat
sources. Fire and/or explosion hazard!
Please read the garden tool operating instructions prior
„
to storing the engine.
Let engine cool off.
„
Store engine in a well-ventilated room, not in the
„
vicinity of naked flames or heat sources.
Avoid the following areas for storage:
„
Close to naked flames.
„
Close to heat sources.
„
Where electric motors are operated.
„
Where electric power tools are used.
„
Drain fuel from engines that will be stored for more than
„
30 days, or add a stabilising fuel agent. Otherwise de-
posits may form in the fuel system.
Maintenance
Danger!
Always switch off and secure engine prior to carry-
ing out any adjustments, maintenance or repairs.
Remove ignition cable from the spark plug (Component
„
index Item 6) and keep it away from the spark plug
Carburettor adjustment
Adjustments to the carburettor must only be made
by authorised service centres or by our repair ser-
vice.
Checking ignition spark
Sparks may cause fire or electric shock.
Use a suitable spark tester.
„
Never check spark when spark plug is removed.
„
474169_c
Repairs
Repairs must only be made by authorised service
centres or by our repair service.
Only use original AL-KO spare parts!
„

Maintenance and care

Danger!
Always switch off and secure engine prior to any
adjustments, maintenance and repairs.
Remove the spark plug cap prior to carrying out any
„
maintenance or repairs.
Do not hose down the engine with water!
„
Water ingress (ignition system, carburettor etc) may
cause malfunction.
Clan the equipment after every use.
„
Take note of maintenance schedule.
„
Follow the hourly or annual intervals, depending on
„
which occurs first.
More frequent maintenance is required under more se-
„
vere operating conditions.
Changing the air filter
Clean the air filter regularly. Replace damaged air filter.
1. Remove the air filter cover (D).
2. Remove filter (E) and knock it out against a hard sur-
face until the dirt has been removed. Do not brush
out! Reinstall the filter.
3. Install air filter cover again and lock in place.
(Figure 2)
GB
17