Class 5 Status Codes - Fronius Symo 10.0-3 208-240 Manual De Instrucciones

Code Description
458 Error during measuring signal detection
459 Error during measuring signal detection
for insulation test
460 Reference power source for the digital
signal processor (DSP) is operating out-
side of tolerances
461 Error in DSP data memory
462 Error in DC feed-in monitoring routine
463 AC polarity reversed, AC connector
plugged in incorrectly
474 RCMU sensor faulty
475 Insulation error (connection between so-
lar module and ground)
476 Supply voltage for driver too low
480 - Function incompatibility (one or more PC
481 boards in the inverter are not compatible
with each other, e.g., after PC board re-
placement)
482 Setup interrupted after initial commis-
sioning
483 Voltage U
DCfix
of valid range
485 CAN transmission buffer is full
*) If status code persists: Contact a Fronius-trained service technician
**) If this status code keeps recurring, contact your system installer
Class 5 Status Class 5 status codes generally do not impair grid power feed operation, but can lead to lim-
Codes itations. They will be displayed until the status code is acknowledged by pressing a key (the
inverter, however, continues working normally in the background).
Code Description
502 Insulation fault on solar mod-
ules
509
No feed-in within the last 24
hours
515 No internal communication
with filter
516 Communication with memory
unit not possible
50
for MPP2 string is outside
Behavior
Warning message is
shown on the display
Warning message is
shown on the display
Warning message on
the display
Warning message of
memory unit
Behavior
Inverter does not feed ener-
gy into the grid.
Inverter does not feed ener-
gy into the grid.
Inverter does not feed ener-
gy into the grid.
Inverter does not feed ener-
gy into the grid.
Inverter does not feed ener-
gy into the grid.
Inverter does not feed ener-
gy into the grid.
Remedy
**)
Acknowledge status code;
Check whether all conditions for
problem-free grid power feed opera-
tion are met (e.g., whether solar mod-
ules are covered with snow); **)
*)
*)
Remedy
*)
**)
Update inverter firm-
ware; *)
Restart setup after AC
reset (switch automatic
circuit breaker off and
on)
Check MPP settings; *)
Carry out AC reset
(switch automatic circuit
breaker off and on); *)