Ryobi TSS120L Manual Del Operador página 21

Your saw has several scale indicators. After squaring
adjustments have been made, it may be necessary to loosen
the indicator screws and reset them to zero. See Figures
25 - 26.
SQUARING THE BLADE TO THE MITER TABLE
See Figures 27 - 29.
 Unplug the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Loosen the miter lock handle approximately one-half turn
and squeeze the detent release lever.
 Rotate the miter table until the scale indicator on the
control arm is positioned at 0°.
 Release the detent release lever, then tighten the miter
lock knob to secure the miter table.
 Loosen the bevel lock knob and set saw arm at 0° bevel
(blade set 90° to miter table). Tighten bevel lock knob.
 Place a combination square against the miter table and
the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 Rotate the blade by hand and check the blade-to-table
alignment at several points.
 The edge of the square and the saw blade should be
parallel as shown in figure 27.
ASSEMBLY
SLIDING
MITER
FENCE
21 − English
BEVEL
LOCK KNOB
BEVEL
SCALE
SCALE
INDICATOR
INDICATOR
SCREW
MITER
SCALE
MITER
TABLE
COMBINATION
SQUARE
MITER
LOCK HANDLE
CORRECT VIEW OF BLADE
SQUARE WITH MITER TABLE
INDICATOR
SCREW
Fig. 25
SCALE
INDICATOR
Fig. 26
BLADE
Fig. 27