Ryobi TSS120L Manual Del Operador página 34

DANGER:
Laser radiation. Avoid direct eye contact with light source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein can result
in hazardous radiation exposure.
TO ADJUST THE LASER GUIDE
See Figure 46.
 Set miter and bevel angles to 0º and lock in place.
 Use the work clamp, C-clamp, or other suitable clamp
to secure a piece of scrap wood.
 Plug the saw into the power source and make a slight
cut to score the wood.
 Release the switch trigger and allow the saw blade to
stop rotating before raising the blade.
 Using a padlock, lock the switch trigger to make the saw
inoperable.
 Turn on the laser guide.
 To adjust the position of the laser, rotate the laser
adjustment screw. Turn the screw clockwise to move the
laser to the right and counterclockwise to move the laser
to the left.
NOTE: When properly aligned, the laser should be on
the left edge of the kerf. If laser does not align correctly,
return to your nearest AUTHORIZED SERVICE CENTER
for repair.
ADJUSTMENTS
LASER
GUIDE
34 − English
LASER
ADJUSTMENT
SCREW
Fig. 46