Ryobi TSS120L Manual Del Operador página 9

KNOW YOUR COMPOUND MITER SAW
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
12 in. BLADE
A 12 in. blade is included with the compound miter saw.
It will cut materials up to 3-1/2 in. thick or 13-1/2 in. wide,
depending upon the angle at which the cut is being made.
BASE/CROWN INDICATOR
See Figure 2.
To cut base or crown molding in the upright position, align
the arrow on the base/crown indicator with the arrow on
the pivot assembly and tighten the slide lock knob securely.
BEVEL LOCK KNOB
See Figure 3.
The bevel lock knob securely locks your compound miter
saw at desired bevel angles. A positive stop adjustment
screw has been provided on each side of the saw arm.
These adjustment screws are for making fine adjustments
at 0° and 45°.
CARRYING HANDLE
See Figure 3.
For convenience when carrying or transporting the miter
saw from one place to another, a carrying handle has been
provided on top of the saw arm. To transport, turn off and
unplug the saw, then lower the saw arm and lock it in the
down position by depressing the lock pin towards the saw
housing.
NOTE: DO NOT perform any cutting operation with the saw
in the locked position.
DETENT OVERRIDE
See Figure 4.
The detent override allows the miter table to move freely to
any desired angle. With the miter lock handle loosened and
the detent release lever squeezed (1), pull the detent over-
ride up (2) and release the detent release lever (3) to bypass
the positive stops on the miter scale. To release the detent
override and allow the miter table to engage the positive
stops, squeeze and release the detent release lever.
ELECTRIC BRAKE
An electric brake has been provided to quickly stop blade
rotation after the switch is released.
LASER GUIDE
For more accurate cuts, a laser guide is included with the
miter saw. When used properly, the laser guide makes
accurate, precision cutting simple and easy.
FEATURES
CARRYING
HANDLE
"D"
HANDLE
SAW ARM LOCKED IN DOWN POSITION
LASER GUIDE SWITCH
See Figure 3.
Use the laser guide switch to turn the laser guide on and off.
9 − English
BASE/CROWN
INDICATOR
ALIGN
ARROWS
LASER GUIDE
SWITCH
LOCK KNOB
SLIDE
LOCK KNOB
PIVOT
ASSEMBLY
Fig. 2
LOCK
PIN
BEVEL
Fig. 3