Storage; Care And Service; Troubleshooting Guide - Kärcher NT 22/1 Ap Bp Manual Del Usuario

Storage

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device
during storage.
The device may only be stored in-
doors.
1. Open the battery cover.
2. Press the unlocking button and re-
move the battery pack to prevent
discharge.

Care and service

DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the battery pack.
ATTENTION
Care agents containing silicone
These can attach plastic components.
Do not use care agents containing sili-
cone for cleaning.
 You can perform basic maintenance
and care work yourself.
 Clean the surface of the device and
the interior of the container regularly
with a moist cloth.
 Regularly check the device-side
contacts for contamination with the
battery cover open and clean with a
damp cloth if necessary. Do not use
detergents.
Replacing the flat fold filter
1. Unlock and remove the suction
head.
2. Turn the suction head by 180 ° and
set it down.
3. Release the locks on the filter cover.
4. Open the filter cover.
5. Remove the flat fold filter.
10
6. Dispose of the used flat fold filter in
accordance with statutory regula-
tions.
7. Remove any dirt deposits from the
clean air side.
8. Fit the new flat fold filter.
9. Close the filter cover.
10.Lock the filter cover in place.
11.Fit and lock the suction head.
Changing the fleece filter bag
1. Unlock and remove the suction
head.
2. Pull the fleece filter bag out to the
rear.
Illustration E
3. Fold in the lock latch and seal the
fleece filter bag tight.
4. Dispose of the used fleece filter bag
in accordance with statutory regula-
tions.
5. Fit the new fleece filter bag.
6. Fit and lock the suction head.
Cleaning the electrodes
1. Unlock and remove the suction
head.
2. Clean the electrodes and the gap
between the electrodes with a
brush.
3. Fit and lock the suction head.

Troubleshooting guide

DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the battery pack.
Suction turbine switches off
1. Empty the container.
Suction turbine does not switch on
again after emptying the container
1. Switch off the device and wait for 5
seconds. Switch on the device.
English