Setting Using Wheel Circumference; Setting The Clock - VDO X Serie Manual De Instrucciones

Ocultar thumbs Ver también para X Serie:
Tabla de contenido

Publicidad

GB
SLO
PL
JP

5.2.2 Setting using wheel circumference

To enter the wheel size manually, you must first
measure the wheel roll circumference on your bike.
Measuring wheel roll circumferences:
step 1 Precisely align valve on the front wheel
vertically to the ground.
step 2 Mark this spot on the ground with a line
(e.g. chalk).
step 3 Push the bike forwards one turn of the
wheel until the valve is vertical to the ground
again.
step 4 Also mark this spot on the ground.
step 5 Measure the distance between the two
marks.That is your wheel circumference
(=roll circumference).
step 6 Enter the wheel circumference measured
in this way into your VDO computer.
ATTENTION: If you have selected KMH display,
you must enter the wheel circumference in mm
(If MPH display is selected, enter the wheel
circumference in inches).
12
X1
>>> P05
How to set the wheel size manually:
Using
go to SETTINGS/
SELECT. Confirm with
M
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode)
Using
go to WHEELSIZE/
SET. Confirm with
.
M
MEASUREMENT/KMH.
Confirm with
M
or
to
change to MPH.
WHEELSIZE/BIKE 1.
(use
to go to setting for
bike 2) Confirm with
M
.
Using
go to
WHEEL-SIZE/MANUAL SET.
Confirm with
M
.
VDO CYCLECOMPUTING
BIKE 1 ...SET SIZE/CONTINUE
Now set the wheel roll circum-
ference measured using
Confirm the entry with
M
.
BIKE 1/SET OK? Confirm with
M
.
The display confirms: WHEELSIZE/SET DONE.
Automatic return to SETTINGS/SELECT.

5.3 Setting the clock

How to set the clock:
Using
go to SETTINGS/
SELECT. Confirm with
M
.
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode)
Using
go to CLOCK/SET.
Confirm with
M
.
CLOCK/24-H-MODE (you can
switch to 12-H mode using
Confirm with
.
M
www.vdocyclecomputing.com
JP
PL
ATTENTION: The factory settings for bike 1 = 2155 mm
and for bike 2 = 2000 mm. If you do not enter any
wheel sizes, the computer works with these fac-
.
tory settings. The values measured in this way
for speed, distance etc. can differ widely from
the actual values.
CLOCK...SET HOUR/CONTINUE
Set the hours using
Confirm the hour setting
with
M
.
CLOCK...SET MINUTES/
CONTINUE. Set the minutes
using
. Confirm the
minutes setting with
CLOCK/SET OK? Confirm with
M
.
.
The display confirms: CLOCK/SET DONE.
Automatic return to SETTINGS/SELECT.
SLO
GB
.
M
.
X1
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

X1

Tabla de contenido