Setting Using Wheel Circumference; Setting The Clock - VDO X Serie Manual De Instrucciones

D GB F I

5.2.2 Setting using wheel circumference

To enter the wheel size manually, you must first
measure the wheel roll circumference on your bike.
Measuring wheel roll circumferences:
step 1 Precisely align valve on the front wheel
vertically to the ground.
Step 2 Mark this spot on the ground with a line
(e.g. chalk).
step 3 Push the bike forwards one turn of the
wheel until the valve is vertical to the ground
again.
Step 4 Also mark this spot on the ground.
Step 5 Measure the distance between the two
marks.That is your wheel circumference
(=roll circumference).
Step 6 Enter the wheel circumference measured
in this way into your VDO computer.
ATTENTION: If you have selected KMH display,
you must enter the wheel circumference in mm
(If MPH display is selected, enter the wheel
circumference in inches).
30 X1
>>> P05
How to set the wheel size manually:
Using go to SETTINGS/
SELECT. Confirm with M
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode)
Using go to WHEELSIZE/
SET. Confirm with .
M
MEASUREMENT/KMH.
Confirm with M or to
change to MPH.
WHEELSIZE/BIKE 1.
(use to go to setting for
bike 2) Confirm with M .
Using go to
WHEEL-SIZE/MANUAL SET.
Confirm with M .
VDO CYCLECOMPUTING
BIKE 1 ...SET SIZE/CONTINUE
Now set the wheel roll circum-
ference measured using
Confirm the entry with M .
BIKE 1/SET OK? Confirm with M .
The display confirms: WHEELSIZE/SET DONE.
Automatic return to SETTINGS/SELECT.

5.3 Setting the clock

How to set the clock:
Using go to SETTINGS/
SELECT. Confirm with M .
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode)
Using go to CLOCK/SET.
Confirm with M .
CLOCK/24-H-MODE (you can
switch to 12-H mode using
Confirm with .
M
www.vdocyclecomputing.com
I
ATTENTION: The factory settings for bike 1 = 2155 mm
and for bike 2 = 2000 mm. If you do not enter any
wheel sizes, the computer works with these fac-
. tory settings. The values measured in this way
for speed, distance etc. can differ widely from
the actual values.
CLOCK...SET HOUR/CONTINUE
Set the hours using
Confirm the hour setting
with M .
CLOCK...SET MINUTES/
CONTINUE. Set the minutes
using . Confirm the
minutes setting with
CLOCK/SET OK? Confirm with M .
. The display confirms: CLOCK/SET DONE.
Automatic return to SETTINGS/SELECT.
F GB D
.
M .
X1 31