Setting The Total Kilometres; Switch From Bike1 To Bike2; Service Interval Display - VDO X Serie Manual De Instrucciones

D GB F I

5.4 Setting the total kilometres

You can program the values on the distance coun-
ter at any time (e.g. at the end of a season).
Using go to SETTINGS/
SELECT. Confirm with M .
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode).
Using go to ODOMETER/
SET. Confirm with M .
5.5 Switch from Bike 1 to Bike 2
Your VDO computer can be used on two bikes.
If you switch from bike 1 to bike 2, you must set the
computer to the bike being used before the ride.
Using go to SETTINGS/
SELECT. Confirm with M .
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode).
32 X1
ODOMETER/ODO BIKE 1
(use to go to setting for
BIKE 2). Confirm with M .
ODO BIKE 1 ...SET DISTANCE/
CONTINUE.
You can set the flashing digits
using .
To access the next digit, con-
firm with M . Repeat the steps
until the last digit on the right
is flashing. Confirm with
ODO BIKE 1/SET OK? Confirm with M .
The display confirms ODO BIKE 1/SET DONE.
Automatic return to SETTINGS/SELECT.
Using go to BIKE/SELECT
Confirm with M .
BIKE 1 (use to switch to
bike 2). Confirm with .
M
VDO CYCLECOMPUTING
BIKE 1 /SELECT OK? Confirm with
The display confirms BIKE/SELECT DONE
Automatic return to SETTINGS/SELECT
The selected bike 1 or 2) is
shown on the display bottom
left. ( )
.
M

5.6 Service interval display

The VDO service interval display reminds you to
have your bike checked in the workshop.
You can switch the service interval ON or OFF.
You can set separate service intervals for 2 bikes
When the set service interval distance has been
reached:
The -symbol flashes on the display.
B
The information line displays
B
BIKE SERVICE/BIKE 1
You should now either carry out the recommend-
ed bike check yourself or have the bike checked
by your dealer.
Press any button. The text BIKE SERVICE disap-
pears again. After another 50 km the
appears. You can also switch off the flashing
symbol. To do so, enter the service interval again.
www.vdocyclecomputing.com
M . ATTENTION, important note: When switching
from bike 1 to 2 or vice versa, the data for day's
tripdistance, ride time, average speed and max.
speed for the last trip are set to zero.
How to set the service interval:
Using
SELECT. Confirm with
You are now in setting mode
(pressing
you back to function mode).
Using
SET. Confirm with
-also dis-
BIKE SERVICE/ON (switch to OFF
using
I F GB D
go to SETTINGS/
M .
for 3 seconds gets
C
go to BIKE SERVICE/
M .
). Confirm with .
M
X1 33