Technical Parameters; Environment Protection - GRAPHITE 58G486 Manual Del Usuario

When installing cutting blade observe correct direction of the teeth. Arrow on the saw body shows
direction of spindle rotation.
REPLACEMENT OF CARBON BRUSHES
Replace immediately used up (shorter than 5 mm), burnt or cracked motor carbon brushes. Always replace
both brushes at a time.
●
Unscrew brush covers (
●
Remove used brushes.
●
Remove any carbon dust with compressed air.
●
Insert new carbon brushes (
●
Install brush covers ( 16).
After the brushes are replaced start the power tool with no load and wait until the brushes fit to the
motor commutator. Entrust replacement of carbon brushes only to a qualified person. Only original
parts should be used.
All faults should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Parameter
Supply voltage
Current frequency
Rated power
Spindle rotational speed with no load
Bevel range
Outer diameter of cutting blade
Hole diameter of cutting blade
Maximum thickness of cut wood Right angle
Protection class
Weight
Year of production
NOISE LEVEL AND VIBRATION PARAMETERS
Sound pressure: Lp = 92.1 dB(A) K = 3 dB(A)
A
Sound power: Lw = 103.1 dB(A) K = 3 dB(A)
A
Vibration acceleration: a
h
Do not dispose of electrically powered products with household wastes, they should be utilized
in proper plants. Obtain information on wastes utilization from your seller or local authorities.
Used up electric and electronic equipment contains substances active in natural environment.
Unrecycled equipment constitutes a potential risk for environment and human health.
* Right to introduce changes is reserved.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with seat in Warsaw at ul. Pograniczna
2/4 (hereinafter Grupa Topex) informs, that all copyrights to this instruction (hereinafter Instruction), including, but not
limited to, text, photographies, schemes, drawings and layout of the instruction, belong to Grupa Topex exclusively and are
protected by laws accordingly to Copyright and Related Rights Act of 4 February 2004 (ustawa o prawie autorskim i prawach
pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments). Copying, processing, publishing, modifications for
commercial purposes of the entire Instruction or its parts without written permission of Grupa Topex are strictly forbidden
and may cause civil and legal liability.
16) (fig. E).
fig. F) (brushes should easily move into brush-holders).

TECHNICAL PARAMETERS

Circular Saw
Bevel (45 0
)
= 2.092 m/s 2 K = 1,5 m/s 2

ENVIRONMENT PROTECTION

Value
230 V AC
1200 W
5000 rpm
0
185 mm
20 mm
65 mm
43 mm
3.8 kg
19
50 Hz
0 - 45°
II
2014