Remote Control - SOUNDMASTER UR600SW Manual Del Usuario

Remote Control

Infrared Transmitter
1.
STANDBY button
2.
SNOOZE button
3.
AUX Button
4.
Button
5.
6. / Button
7. VOLUME + / - Button
MUTE Button
8.
9. ST. / MONO Button
10. EQ Button
11. SLEEP Button
12. BT. Button
13. RADIO Button
14. CH + / - Button
15. TUN + / - Button
16. CLOCK Button
17. ALARM / MEM Button
18. DIMMER Button
19. Battery Compartment
Clock setting / Memory battery back-up
A backup battery compartment located at rear of the unit.
(1) Loose the battery compartment screw.
(2) Open the clock / Memory battery compartment lid.
(3) For the first time use: just remove the insulation tag.
For battery replacement: install a DC 3V CR2032 type Lithium battery (with the polarity plus side facing up).
(4) Close the battery compartment lid.
(5) Screw tight the compartment lid.
Remote Control
The remote control operates on one CR2025 Lithium battery (included).
To activate the remote control, remove the insulation tag attached in the battery compartment.
Connecting the unit to the AC adaptor power
Plug the AC Adaptor's DC plug into the DC Jack on the back of unit.
Plug the adaptor into a standard AC mains outlet.
- Turn the unit on and off.
- Activate the snooze function.
- Press to select AUX-IN mode.
- Bluetooth music Play/Pause function.
- In Bluetooth mode: Skip tracks Backward / Forward.
- Adjust the output volume level.
- Mute the volume.
- Select FM radio stereo/mono receiving mode.
- Select preset EQ (Bass / Pop / Rock / Jazz / Classic / Off ).
- Select the time duration of the sleep timer.
- Press to select Bluetooth mode.
- Press to select FM Radio mode.
- In radio mode: Select preset station channel.
- In radio mode: Tune the radio frequency up/down.
- Set clock and 12/24 hour format.
- Set alarm time and select alarm source.
- In radio mode: Enter saving preset radio station mode.
- Turn LED display bright/dim.
Installation
UR600SW / English Instruction Manual
2