Alarm Operation - SOUNDMASTER UR600SW Manual Del Usuario

The unit incorporated dual alarm timer, alarm 1 and alarm 2. You may set the two alarm time individually. It wakes
you up from Buzzer (Beep) or from FM Radio.
When the unit is OFF (Standby mode):
Alarm1 time setting
1. Press and hold the ALARM button until the ALM 1 (alarm 1) LED indicator blinks.
2. Press the TUN + / - button to set alarm1 hour.
3. Press the ALARM button again, the alarm1 minute blinks.
4. Press the TUN + / - to set alarm1 minute.
Select alarm1 wake up source
Press the ALARM button and alarm source indicator BUZZER ("bP") or RADIO (" frequency
5.
digits " ) displays.
6. Press the TUN + / - button to select alarm source.
Alarm2 time setting
7. Press the ALARM button again and the ALM 2 (alarm2) LED indicator blinks.
8. Repeat same steps 2 to 4 above.
Select alarm2 wake up source
9. Repeat same steps 5 to 6 above.
Save settings and activate alarm function
10. To save all settings and exit the setting mode, press the ALARM button or wait for few seconds.
11. To activate the daily alarm, press the ALARM button and the corresponding alarm LED indicator (ALM 1 /
ALM 2) should appear on the display.
Notes:
- When "Wake to Radio" is selected, make sure the radio station which you want to wake to is tuned.
Wake to Buzzer/Radio
- When the alarm time is reached, the alarm sounds.
(a) Alarm sound source Radio : activate the radio for 60 minutes.
(b) Alarm sound source Buzzer : buzzer sounds for 60 minutes.
You can activate the snooze function manually after the alarm sounds by pressing the SNOOZE button. The
-
SNZ status LED Indicator lights. The alarm sound stops for the snooze time (around 9 to 10 minutes) then
comes again.
- The snooze operation can be activated within 50 minutes from the set alarm time.
- To cancel the snooze before it expires, press the ALARM button.
- To stop the alarm immediately after the alarm sounds, you can also press the ALARM button once. It resets
itself for the following day.
Sleep to timer
This feature allows you to fall asleep to the radio for up to 90 Minutes.
The unit shuts off automatically when the time expires.
1. Press the Power button to turn the unit on.
2. Tune to the desired radio station in radio mode.
3. To select the sleep timer to turn the unit off after 10, 20, 30, 40, 50, 60 or 90 minutes, press the SLEEP button
repeatedly. The SLP status LED Indicator lights. The unit plays for the selected length of time then automatically
turns off.
4. To view the remaining sleep time, press the SLEEP button once.
5. To turn the unit off before the sleep timer counts down to zero, press and hold the Power
Notes:
If you are falling asleep to music from an external device connected to the AUX input or from the paired
Bluetooth device, the sleep timer will shut off the power to this system but it will not turn off the external device.
5

Alarm Operation

Sleep Timer Function
UR600SW / English Instruction Manual
button at any time.