SOUNDMASTER UR600SW Manual Del Usuario página 15

Resetting the Unit
If the unit experiences a power surge or electric shock, it is possible that the internal micro-controller may lock up
and the unit will not respond to any commands from the panel controls.
1. In this event, unplug the AC power plug from the wall outlet.
2. Loose the battery compartment screw and take out the CR2032 battery.
3. Wait for few minutes then install the CR2032 battery back into the compartment.
4. Reconnect the AC power plug into the wall outlet and with the DC plug connected to the DC input jack of the
unit.
Note:
The reset operation clears the system memory and all of your previous settings will be erased.
POWER REQUIREMENT
Power Adaptor
Power Supply to the Unit
Clock / Memory back-up battery
Remote Control battery
THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE SET ARE SUBJECT TO CHANGE WITHOUT
PRIOR NOTICE.
UR600SW / English Instruction Manual
Specifications
AC-DC adaptor Input: 100V – 240V ~ 50/60Hz
Output: DC 5V 2000mA
DC 5V 2000mA
DC 3V CR2032 type Lithium battery
DC 3V CR2025 type Lithium battery
6