2.
While maintaining alignment of dimple and trough, bounce middle pole section (10) into top
pole section (9) using a wood scrap as shown until the top pole (9) is aligned with the marked
line on the middle pole (10).
You should have a 3 1/2" (8,9 cm) of overlap when properly assembled.
CAUTION!
WHEN PROPERLY POUNDED
TOGETHER, THE POLE SECTIONS
SHOULD HAVE A 3-1/2" (8,9 CM)
OVERLAP.
IMPORTANT!
Align dimple of top pole section (9) into trough
of middle pole section (10) as shown.
MIDDLE POLE
MARKED LINE
TROUGH
DIMPLE
TOP POLE
10
9
MARK LINE
3 1/2"
(8,9 cm)
HOLE
11
10
MIDDLE POLE
9
TOP POLE
Wood Scrap
(not supplied)