SPALDING M620022 Manual Del Usuario página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.
While maintaining alignment of dimple and trough, bounce top and middle pole
assembly (9 and 10) onto bottom pole section (11) using a wood scrap as
shown. Bounce until the top and middle pole assembly (9 and 10) is aligned
with the marked line on the bottom pole (11).
You should have a 3 1/2" (8,9 cm) of overlap when properly assembled.
CAUTION!
WHEN PROPERLY POUNDED
TOGETHER, THE POLE SECTIONS
SHOULD HAVE A 3-1/2" (8,9 CM)
OVERLAP.
IMPORTANT!
Align dimple of middle pole section (10) into
trough of bottom pole section (11) as shown.
10
MIDDLE POLE
DIMPLE
TROUGH
MARKED LINE
11
BOTTOM POLE
ID# M6611742
07/08
HOLE
MARK LINE
3 1/2"
(8,9 cm)
12
9
TOP POLE
10
MIDDLE POLE
11
BOTTOM POLE
Wood Scrap
(not supplied)

Publicidad

Tabla de contenido
loading

Tabla de contenido