Programming; Service Menu - Lowara SM30 BSETF3 Instrucciones Para La Instalación Y El Uso

en
The parameter to be changed appears between two square brackets [ ] if it is part of a list, while for
numerical values a blinking cursor indicates the figure to be changed; in both cases, use the ↑UP and
↓DOWN buttons to change the value.
If a parameter is a number of several figures, these are changed separately, press OK/MENU to move on
to the next figure.
Once the desired value has been obtained, press OK/MENU to confirm the value or press P3 (ESC) to
cancel.
To leave a menu or a submenu, press P3 (ESC) or repeatedly press the ↑UP or ↓DOWN key until it gives
the message EXIT, select YES and confirm with OK/MENU .
Default Values
The default values are those set in the factory and they may be reset on the DEFAULT menu.

6 PROGRAMMING

CAUTION

6.1 Service menu

Modifications to the service menu must be made by qualified personnel.
When switching on the board, press the OK/MENU and ↑UP buttons until this message appears on the
display:
Set the password 00066 with the ↑UP and ↓DOWN buttons and confirm with OK/MENU to enter the
service menu.
If the password is wrong, the menu is proposed in read-only mode and this window appears:
Display Comment
LANGUAGE Language setting.
Some languages may not be active, in this
case the messages are automatically displayed
in Italian.
AUTO ENABLE Modification of some parameters enabled in
AUTOMATIC mode.
38
The adjustments may influence correct operation of the set.
PASSWORD SERVICE
WRONG PASSWORD
READ ONLY
[00066]
Field
ITALIANO,
ENGLISH,
FRANÇAIS,
DEUTSCH,
PORTUGUÊS,
ESPANÕL
NEDERLANDSE
SVENSKA
SUOMEN
РУССКИЙ
YES
NO
Default
ITALIANO
NO