Fitting; Electrical Connection; Maintenance And Repair Work - Teka FGKST 58 Serie Instrucciones Para El Uso Y Montaje

Encimera vitrocerámica de encastrar con mando touch control
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
GB

4. Fitting

4.1 Electrical connections
(Connected loads and model designation: see front of the operating instructions)
This appliance may only be connected to the electricity supply by an approved electrician who must ensure
that the installation complies with the statutory regulations (Germany VDE, Austria ÖVE, Switzerland SEV,
etc.). The electrician must ensure that these regulations and those laid down by the local electricity supply
company are observed.
When connecting the electrical appliance, install an all-pole disconnecting device with a contact gap of at
least 3 mm. Make sure that the local mains voltage is the same as the voltage on the nameplate.
To connect the appliance, unscrew the switchbox cover on the underside of the appliance to access the
terminal block. After connecting the appliance, replace the cover and secure the connection cable with the
strain relief clamp.
The connection cable must be at least HO5 VVF.
Make sure that the excess cable length is not laid in the hob's installation area.
See Fig. 4 for the position of the cable cut-out.
Electrical connections

4.2 Maintenance and repair work

Before repair work is carried out, disconnect the appliance from the mains. If you have to contact our service
department, always quote the type and make numbers. You can find these numbers on the nameplate or on
page 1 of the Operating Instructions. Each time the glass ceramic hob is removed from the worktop, check the
seals and replace if necessary.
4.3 Working surface cut-out
Carry out all cutting out of furniture units and worktops before fitting the
appliance, and remove all sawdust and chips.
The dimensions of the worktop recess can be seen in the dimension
drawing (Figs. 1+2).
The cut sections should be sealed with a water-repellent protection
paint.
The worktop and the hob must be fitted horizontally. A tilted hob is
under tension and this increases the danger of breaking.
18
223279

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fgkst 75 serieGkst 58 serieGkst 75 serie

Tabla de contenido