Final Assembly - Emerson Blade Select Serie Manual Del Usuario

6.1
Remove One #6-32 x 3/8" Truss Head Screw with
Lockwasher from the Motor Hub and retain for later use
(Figure 21).
Loosen the other Two #6-32 x 3/8" Truss Head Screws
with Lockwashers on the Motor Hub for the installation of
the Switch Housing Adapter (Figure 21).
6.2
Place the Motor Hub Connector through the Center Hole
of the Switch Housing Adapter.
Install the Switch Housing Adapter onto the Motor Hub by
aligning and engaging the Two Keyhole Slots of the
Switch Housing Adapter with the Two Loosened Screw
Heads on the Motor Hub.
Rotate the Switch Housing Adapter Clockwise to engage
both Loosened Screws (Figure 22).
Reinstall the previous removed #6-32 x 3/8" Truss Head
Screw with Lockwasher (Figure 22).
Secure the Switch Housing Adapter to the Motor Hub by
tightening the Three Motor Hub Screws.
A spare #6-32 x 3/8" Truss Head Screw with Lockwasher
is provided in parts bag, if needed.

6. Final Assembly

LOOSEN TWO
#6-32 x 3/8"
TRUSS HEAD
SCREWS WITH
LOCKWASHERS
Figure 21
Figure 22
15
MOTOR HUB
REMOVE ONE
#6-32 x 3/8"
TRUSS HEAD
SCREW WITH
LOCKWASHER
MOTOR HUB
SWITCH
HOUSING
ADAPTER
REINSTALL
#6-32 x 3/8"
TRUSS HEAD
SCREW WITH
LOCKWASHER