Siemens SITRANS FUG1010 IP65 NEMA 7 Compact Guia De Inicio Rapido página 31

Table 3- 6 CC129 Damping Material Thickness for Clamp-On Gas systems
Transducer Size
B1H
B2H
B3H
C1H
C2H
D1H
D2H
D3H
D4H
Note
After Transducers are mounted scroll to [Install Complete?] and select [Install.
Note
Check to make sure that the transducers are a matched set with the same serial numbers
and marked with an "A" and "B" (e.g., 19256A and 19256B).
Reflect Mount using Mounting Frames and Spacer Bar
● After receiving the spacing index from the Installation Menu, prepare the pipe surface
● Degrease the surface and remove any grit, corrosion, rust loose paint, etc.
Before beginning refer to the Reflect Mount Installation diagram example below.
SITRANS FUG1010 Quick Start
Operating Instructions (Compact), 1/2009, CQO:QSG005 Revision B
CC129-1A Lit P/N
CC129-1A-1
CC129-1A-1
CC129-1A-1
CC129-1A-1
CC129-1A-1
CC129-1A-2
CC129-1A-3
CC129-1A-2
CC129-1A-4
Operating Temperture Rnage
-23 to 93°C (-10 to 250°F)
area where the transducers will be mounted.
Required Layers Final Thickness (in)
1
1
1
1
1
2
3
2
4
0 to 50°C (32 to 120°F)
Commissioning
3.5 Transducer Installation
Final Thickness (mm)
0.027
0.027
0.027
0.027
0.027
0.054
0.081
0.054
0.108
Installation Temperature Range
0.69
0.69
0.69
0.69
0.69
1.37
2.06
1.37
2.74
29