Siemens SITRANS FUG1010 IP65 NEMA 7 Compact Guia De Inicio Rapido página 44

Appendix A
A.1 I/O Connections and Wiring
Terminal Block Wiring - 1010DXS2-7
(Refer to manual drawing 1010DXS2-7 sheet 4 of 4. When Barriers are used, isolation is
limited to the Barrier's working voltage. Refer to table on manual drawing 1010-341 sheet 3).
These connection diagrams apply to the part numbers listed below.
Table A- 4
FUG1010
Note
Wiring diagram for FUG1010DX TB1 is the same as Table A-1.
Table A- 5
Pin#
Note
Wiring diagram for FUG1010DX TB2 is the same as Table A-2.
42
Part Numbers and Connection Diagrams
FUG1010DX Input/Output Wiring (TB1)
Signal
1 Io2 -
2 Io2 +
3 Io1 -
4 Io1 +
5 ANIN 2
6 ANIN 1
7 Status -1
8 Status +1
9 PGEN-
10 PGEN+
1010DXS2-7 (Sheet 4 of 4) Drawing
7ME3611-bc
where:
b= 2
c= E
Function
Isolated Loop Return
Isolated Loop Supply
Isolated Loop Return
Isolated Loop Supply
4-20mA Input CH.2
4-20mA Input CH.1
Status Bit Return
Status Output
DPGEN RTN
DPGEN OC
Operating Instructions (Compact), 1/2009, CQO:QSG005 Revision B
Description
4-20mA output proportional to any
available spanned data variable
4-20mA Analog input non-isolated
CH.1 Status Alarm Emitter
CH.1 Status Alarm Collector
Isolated PGEN Emitter
Isolated PGEN Collector
SITRANS FUG1010 Quick Start