diversey swingo 1650 Manual De Instrucciones página 11

Removing and cleaning the suction nozzle
• Pull the suction hose from the connector.
• Lift the suction nozzle with your foot.
• Compress the lock springs. The suc-
tion nozzle is released and can be re-
moved from the squeegee holder.
• Clean the suction nozzle under running water using a
brush.
Notice:
Only cleaned and intact blades ensure optimal suc-
tion results!
Empty and clean the recovery tank and fresh
water tank
• Remove the drain water hose (red) from the holder.
• Put the drain hose into the drainage.
• Press the crushing point (1) of the drain hose.
• Pull the lid off the drain hose and
drain the recovery tank.
1
1
• Proceed in the same way for draining the fresh water tank.
For that purpose, remove the cleaning solution drain hose
(glue) from the holder.
Cleaning the recovery tank and fresh water tank
• Open the tank cover until the support
engages in the tank wall.
• Rinse the recovery tank and the fresh water tank thorough-
ly with clean water.
• Remove the dirt sieve (yellow), emp-
ty it and thoroughly rinse it under run-
ning water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
10
• Check the float to make sure it is fully
functional and repair any fault
• After you have finished emptying the tanks, screw the red
and blue cover back on and hang the hose on the holder.
Caution:
Clogged suction filters may impair the suction per-
formance.
• Reassemble the dirt sieve (yellow) and the suction filter.
• Put the drain hoses back into the holder.
Cleaning the fresh water tank filter
Caution:
Clean the fresh water tank filter after the end of op-
eration.
Clogged filters can inhibit the supply of detergents and
thus lead to surface damage.
• The machine must be switched off.
• Unscrew the fresh water tank filter
and remove it.
• Rinse the filter thoroughly with clean
water.
Notice:
The filter is lower than the drain hole of the tank. A
rest amount of cleaning solution will run out only
when the filter is removed.
• Put the filter back and twist it closed.
Removing and cleaning the brush
Notice:
Clean the brush whenever cleaning work is com-
pleted.
• The machine must be switched off.
• Push the tool ejector briefly but firmly
with your foot.
• Remove the brushes and clean them under running water.
Cleaning the machine
Caution:
Never clean the machine with a high-pressure
cleaner or water jet.
Water ingress in the machine may cause considerable
damage to the mechanical or electrical parts.
• Wipe the machine with a moist cloth.