Batteries; Charging Process - diversey swingo 1650 Manual De Instrucciones

Batteries

Permissible batteries
Traction batteries are required for the use of this machine (no starter
or device batteries). We recommend the use of pure traction batter-
ies. Only these batteries can ensure a long service life.
Traction batteries are produced as open (wet-cell) batteries or as
maintenance-free (VRLA) batteries (Gel and AGM). The machine
must be adjusted accordingly for each design type and manufacturer.
Each battery has a different service life and performance.
The machine must be programmed after the batteries have been in-
serted or if the battery type and/or the manufacturer have been
changed as well as prior to starting the machine.
Incorrect adjustment may result in early battery failure.
Safety measures to be taken when handling
batteries
Batteries contain acid. Always wear safety goggles
when performing maintenance, installing, or remov-
ing wet battery sets.
Rinse acid splashes in your eyes or on your skin with
plenty of clear water. Then immediately consult a
doctor. Wash your clothes with water!
Charging batteries creates a dangerous gas mixture.
Keep away from open fire or glowing embers.
Do not smoke!
Danger of acid burns!
Attention! The battery poles are always energized,
therefore do not place any objects on the batteries!
Caution:
Keep batteries clean and dry. Immediately wipe off
leaking acid or water.
- Wear protective gloves for this purpose.
Caution:
Batteries may only be installed by service agencies
or experts approved by Diversey; they must be in-
stalled in compliance with the connection diagram.
Installation and/or connection errors may result in se-
vere injury, explosion and major damage to the ma-
chine and the environment.
Notice:
The operating instructions provided by the battery
manufacturer must be met.
Caution:
Ensure adequate ventilation when charging the bat-
tery.
Caution:
Always disconnect the batteries from the machine
before starting maintenance work.
Battery connection diagram
swingo 1650/1850 (Gel)
Charger
Mains
external
Battery
plug
75 A
6 V
red
6 V
black
Power Board
swingo 1650/1850 (Lithium)

Charging process

Each battery type and/or battery manufacturer requires different
charging characteristics.
Notice:
Incorrect charging characteristics or the use of in-
appropriate chargers may result in early failure or
the quick destruction of batteries.
Optionally available on-board chargers are adapted to the battery size
and contain several charging curves, which are adjusted ex factory or
by a TASKI service technician for recommended batteries. This regu-
lation shall also apply for the use of stationary (external) chargers.
Caution:
Persistent short-term use with subsequent battery
charging may cause long-term damage to the bat-
teries.
- Standard value: At least approx. 20% of the available
capacity should be used up before recharging the bat-
tery.
Caution:
In order to achieve the maximum possible service
life, traction batteries must run through a complete
charging cycle (12-16 hours) twice a week.
Drive direction
Forward
6 V
6 V
5