Getting Started; Inserting / Removing The Memory Card - Targa WAL 14 A1 Manual De Instrucciones

WAL 14 A1

8. Getting started

For reasons of IT security, please note the following:
Never commission multiple WiFi cameras at the same time and install them in the control app!
Each WiFi camera must be commissioned separately and added to the control app. Only ever
connect one camera per scan. Start a separate scan for each new camera.

8.1. Inserting / removing the memory card

Please note that all the functions of the WiFi camera can only be guaranteed if a Micro SD card
meeting the following specifications is inserted:
Maximum capacity: 128GB, Class 10
The recordings from the camera (3) are saved to a Micro SD card (not included).
The SD card slot is deliberately concealed and not easily accessible in the camera housing. This makes it
difficult for unauthorised persons to remove the SD card. Proceed as follows to insert or replace the SD
card:

Tilt the camera holder (2) by around 70° until it stops.

Remove the screw covering the SD card slot using the
special screwdriver provided.

Remove the cover from the SD card slot.

The SD card slot is directly beneath the cover, still
concealed and protected by a rubber seal. Lift up the
rubber seal to reveal the SD card slot.

Now you can insert or remove the Micro SD card.

When you insert the SD card, make sure the contacts
are facing forwards, using tweezers may help. The SD
card needs to be pushed against the spring until it
locks into the camera.

To remove the SD card, unlock it by pushing against
this spring. Then remove the unlocked SD card from
the SD card slot using tweezers if necessary.

Finally, replace the rubber seal and the cover of the
SD card slot.
38 - English