Restoring Factory Settings; Led Displays - Targa WAL 14 A1 Manual De Instrucciones

8.4. Restoring factory settings

The RESET button on the outdoor camera is deliberately concealed to prevent misuse by unauthorised
persons.
If you have forgotten your password or you wish to restore the factory settings on the outdoor camera for
another reason, proceed as follows:

The screw in the centre of the cover of the RESET
button (4) is covered by a rubber bung. Remove this
with a sharp object such as a small screwdriver.

Now undo the screw in the cover (4) using the special
screwdriver and lift the cover (4) off.

The RESET button can be found in the opening
exposed above the screw thread.

To press the RESET button, push the tip of the special
screwdriver into the opening until you feel it switch.
Press and hold the button down for approx. 10
seconds.

The power LED (5) flashes quickly in red.

8.5. LED displays

LED display
LED flashing quickly in red*
LED flashing green
LED flashes green every 2 seconds for
approx. 2 seconds
*On first setup, the LED (5) flashes quickly in red. If this is not the case, this status can be restored at any
time by pressing the RESET button for about 10 seconds.
Description
Device ready for network setup
Network connection established
Device is working normally
WAL 14 A1
English - 43