Tabla de contenido
Publicidad
EN
For installers
●
Example: For remote control No. 12345678
Do not peel the label from
the seat sensor area.
(It shows the customer
where the seat sensor is.)
Check the numbers on the main unit and remote control
Safety Precautions
Be sure to read these Safety Precautions carefully prior to installation, and always be sure to follow the safety warnings and instructions.
This symbol indicates misuse may result in
death or serious injury.
WARNING
Examples of symbols
This symbol indicates a prohibited use of the
product.
This product is classified as Class 1 Equipment and must be grounded.
●
Install this equipment where the electrical outlet is accessible.
●
Use the new hose set included with this equipment. Do not reuse an old hose set.
●
Do not use this product with any power supply other than the one specified.
(Doing so may result in heat or fire.)
Do not use a damaged power plug, damaged power cord or loose socket outlet.
(Doing so may result in electrical shock or fire.)
Do not install an outlet directly beneath a water supply location. Do not allow the water supply
hose to touch the electrical outlet of plug.
(Condensation may seep into the outlet, resulting in fire or electrical shock.)
Use only potable water according to the laws and ordinances of the region of use.
Do not use seawater or reclaimed water.
(Doing so may result in skin inflammation or other ailments.)
Prohibited
Do not install the product on moving vehicles such as boats or RV's.
(Doing so could cause a fire, electric shock, a short circuit, or other malfunctions. The toilet seat, lid,
product main body or other part might come loose and fall off, resulting in injury.)
Do not do anything that could damage the power cord, power plug.
Do not strike, yank, twist, excessively bend, damage, alter, or heat any electrical cords. Also, do not place
anything heavy on, bind or pinch them.
6
(Using a damaged electrical cord may result in a fire, electrical shock, heat or a short circuit.)
The main unit and remote control are configured as a pair.
Install the included item only.
Remote
control
back side
Main unit
back side
(8 digits) to confirm that they are a pair.
This symbol indicates misuse may result in
injury or physical damage.
CAUTION
The symbol is used to indicate a required step
in the use of this product.
WARNING
Prohibited
12345678
12345678
Required
Prohibited
Required
WARNING
Do not exceed the rated capacity of your electrical outlets or wiring equipment.
(Using a single outlet to supply power to many devices by using an extension cord or other adapters may
result in fire from excess heat.)
Do not use this product in environments subject to temperatures of 0° or below.
(The toilet may freeze and break, causing injury or leaks that may damage property.)
Be sure to plug the electrical cord all the way into the wall socket.
[If the product does not have a power plug]
Confirm that the power cord is connected correctly.
(Failure to do so may result in electrical shock or fire.)
Always use a grounded (3-prong) electrical outlet and that is connected to a ground fault circuit
interrupter (30mA or less).
[Korea, Asia, Oceania, the Middle East, Macau]
Make sure to waterproof the power plug by using a silicon rubber sealant.
(A power plug that has not been waterproofed may cause fire or electric shock.)
*If the power plug is not waterproof, ask the installer to waterproof it.
To unplug, hold the plug, not the cord.
Do not unplug by pulling the cord.
(Pulling on the cord may cause damage and result in fire or heat.)
This is an electrical product. Do not locate it anywhere water is likely to get on it. Do not locate the product in a
humid environment where water may form on the surface of the product. When using the product in a bathroom,
install a ventilation fan or opening, so that the bathroom has sufficient airflow to avoid extreme humidity.
(Failure to do so may result in electrical shock or fire.)
When carrying this product by itself, always hold it by the porcelain section. Carrying it by holding
any other section could break the product, causing injury, material damage or a water leak.
If the electric cord is damaged, avoid danger by having the manufacturer's repair department or
equivalent specialist replace it.
Always connect the product to the cold water supply.
(Connecting to hot water supply may result in burns and equipment damage.)
When installing this product, comply with the regional codes and standards on installation work.
[Korea, Asia, Oceania, the Middle East, Macau]
Check that the product is electrically grounded appropriately.
(If a ground is not installed, a breakdown or electrical current leak may result in electrical shock.)
For a ground, use copper wire with a ground resistance of 100 max. and a diameter of 1.6 mm (1/8") min.
*If there is no ground installed, ask the installer to put in a ground.
Confirm that wiring is connected correctly (L terminal: Live, N terminal: Neutral).
(Incorrect wiring may cause mechanical failure)
All-pole disconnection incorporated in the fixed wiring shall be provided.
CAUTION
Do not subject the toilet to strong forces or impacts.
(Otherwise, the toilet may break, causing injury or leaks that may damage property.)
Do not lift the product by the toilet seat or toilet lid.
(Doing so may result in the product main body dislodging, falling and causing injury.)
Do not excessively bend the flexible water supply hose, or damage it with cigarette fire, a cutter, etc.
(Doing so could damage or cause water leaks in the flexible water supply hose that could result in flooding
damage to property, such as household belongings.)
Do not remove the water filter with the shutoff valve left open.
(Leaving the shutoff valve open could cause water to spray that could result in flooding damage to property,
such as household belongings.)
Carry out the installation work according to this manual.
(Otherwise, damage or water leaks may occur.)
Be sure to use the included or specified parts for installation work.
(Otherwise, parts may not be attached correctly.)
Be sure to carry and install this product with at least two people.
(Otherwise, you could injure your lower back or drop the toilet bowl, causing damage and injury.)
Make sure that the water filter is tight after installation.
(Failure to securely tighten it may cause a water leak.)
Make sure the plus and minus signs on the batteries are aligned correctly before inserting them.
(Otherwise, the batteries may leak fluid, generate heat, rupture, or ignite.)
When the product will not be used for a long time, remove the batteries from the remote control
and the battery box.
(Failure to do so may cause the batteries to leak fluid.)
7
Publicidad
Tabla de contenido
