Kobalt KXCS 124B-03 Manual De Instrucciones página 17

OPERATING INSTRUCTIONS
11. Cross-Cutting/Rip Cutting
When making a cross-cut or a rip cut, align the
guideline with the 90˚ blade-guide notch (M) on
the base. The distance from the saw blade to the
saw base is approximately 1-1/2 in. (3.8 cm) on
the left side of the saw and 5 in. (12.7cm) on the
right side.
Blade thicknesses vary, so you should always
make a trial cut in scrap material along a guideline
to determine how much the guideline must be
offset from the guide to produce an accurate cut.
NOTICE: Use a guide when making long or wide
rip cuts.
12. Rip Cutting Using a Straight Edge
a. Secure the workpiece.
b. Clamp a straight edge to the workpiece using
C-clamps (not included).
NOTICE: Position the C-clamps so that they will not
interfere with the saw housing during the cut.
c. Press the lock-off button (C) and depress the
trigger switch (A) to start the saw.
k. Allow the blade to reach full speed, then guide
the saw into the workpiece and make the cut.
d. Saw along the straight edge to achieve a
straight rip cut.
e. Release the trigger switch and allow the blade
to come to a complete stop.
f. Lift the saw from the workpiece.
NOTICE: Do not bind the blade in the cut.
13. Bevel Cutting
To make the best possible cut:
a. Adjust the angle of cut to any desired setting
between 0° and 50°. Refer to Adjusting the
Cutting Angle.
b. Align the cutting line with the 45° blade-guide
notch (N) on the base when making 45° bevel
cuts.
c. Make a trial cut in scrap material along a
guideline to determine the amount to offset the
guideline on the cutting material.
11
12
13
17
M
N