Monitoring Devices; Installing/Dismantling; During Operation; Maintenance Tasks - Wilo Control EC-Booster Instrucciones De Instalación Y Funcionamiento

2.4

Monitoring devices

2.5

Installing/dismantling

2.6

During operation

2.7

Maintenance tasks

2.8

Operator responsibilities

3

Intended use

Installation and operating instructions Wilo-Control EC/ECe-Booster
Intended use
▪ Replace a defective connection cable immediately.
Circuit breaker
The size and switching characteristics of the circuit breakers must conform to the rated
current of the connected consumer. Observe local regulations.
▪ Locally applicable laws and regulations on work safety and accident prevention must be
complied with.
▪ Disconnect the product from the mains and secure it against being switched on again.
▪ Suitable fixation material must be used for the existing bearing surface.
▪ The product is not watertight. Select an appropriate installation site!
▪ Do not deform the housing during installation. Seals could leak and affect the stated
IP protection class.
▪ The product may not be installed in potentially explosive areas.
▪ The product is not watertight. Comply with protection class IP54.
▪ Ambient temperature: 0 ... 40 °C.
▪ Maximum humidity: 90 %, non-condensing.
▪ Do not open the switchgear.
▪ The user must notify the person in charge of every fault or irregularity immediately.
▪ In case of damage to the product or connection cable, switch off the product immedi-
ately.
▪ Do not use any aggressive cleaners or scouring agents or fluids.
▪ The product is not watertight. Do not submerse the product in fluids.
▪ Only carry out maintenance tasks mentioned in these installation and operating in-
structions.
▪ Only original parts from the manufacturer may be used for maintenance and repairs.
Use of parts other than the original parts releases the manufacturer from any liability.
▪ Provide installation and operating instructions in a language which the personnel can
understand.
▪ Make sure that the personnel has had the corresponding training for the specified work.
▪ Safety and information signs mounted on the device must always be legible.
▪ Train the personnel on how the system operates.
▪ Eliminate risk from electrical current.
▪ To ensure safe working practice, define personnel responsibilities.
Children and persons younger than 16 years or with reduced physical, sensory or mental
capacities or limited experience are prohibited from handling the product! A technician
must supervise persons younger than 18 years!
The switchgear is suitable for the pressure-dependent control of up to three pumps:
▪ Control EC-Booster: uncontrolled fixed-speed pumps
▪ Control ECe-Booster: electronically controlled variable-speed pumps
The signal is acquired using a pressure sensor.
Intended use includes compliance with this manual. Any other use is regarded as non-
compliant with intended use.
en
51