Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TDB3108, WF3208 Terreon
4a
Adaptive infrared assembly for A drain and O drain units
without Tie Pipe option
A
INSTALL HEMMED END (NOT SHARP END) OF SUPPORT TUBE WITH GASKET ONTO BOWL (SEE FIGURE 6).
B
CONNECT 1/2" SUPPLY TUBING TO SPRAYHEAD WITH 3/8" NPT TO 1/2" TUBE CONNECTOR AND PLACE SPRAYHEAD ONTO
SUPPORT TUBE. RUN THE TUBING DOWN THROUGH THE SUPPORT TUBE AND CONNECT TO VALVE TUBE CONNECTOR.
PLACE THE UPPER TIE BAR (NOTCHED AT BOTH CORNERS OF EACH END) ON TOP OF SPRAYHEAD. CONNECT THE LONGER TIE
C
ROD TO THE 4-1/4" TIE ROD USING THE COUPLING NUT WITH HEX HEAD SET SCREWS. RUN THE TIE ROD ASSEMBLY DOWN
THROUGH UPPER TIE BAR (SEE FIGURE 6 INSET) AND SECURE FROM UNDERNEATH THE BOWL USING LOWER TIE BAR (NO
NOTCHES) AND HEX NUT WITH SOCKET HEAD SET SCREW.
TIE ROD PRE-PACK
S45-1336
I.R. MODULE ASSY.
TIE BAR
SUPPORT TUBE
(STD) S57-005
(JUV) S57-006
SUPPORT TUBE
GASKET
125-011
PRE-PACK
S45-055
1/2" SUPPLY TUBE
PRE-PACK
S45-1466
PEDESTAL ASSY.
Figure 6
12
®
54" Circular
S50-344
S17-242
VALVE ASSY.
S50-369
4/6/2007
TIE ROD
PRE-PACK
ACTUATOR
MODULE
ASSY.
COUPLING
SPRAYHEAD
SUPPLY TUBE
A/O UNIT ASSEMBLY
COVER
107-099 (A)
107-179 (O)
NUT
SPRAYHEAD
S05-054
TIE ROD
176-008A
DRAIN
S45-273
TERREON® DEEP BOWL
(ADA bowl shown, classic
bowl is optional)
Part No. varies with color of bowl.
Contact your local Bradley Rep.
for assistance
ACCESS PANEL
186-1456
A/O
(A shown)
Bradley Corporation • 215-1187 Rev. N; EN 06-915B
Installation
COVER
NUT
TIE
BAR
TIE
ROD
SECTION VIEW OF
Publicidad
Tabla de contenido
