Bradley Terreon TDB3108 Instalación página 13

Installation
Installation Instructions continued . . .
D PLACE THE INFRARED MODULE ASSEMBLY ON TOP OF SPRAYHEAD. ROTATE UNTIL INFRARED MODULE LOCKS IN WITH TIE BAR.
DROP TWO INFRARED MODULE WIRES DOWN TO VALVE ASSEMBLY.
NOTE!
Skip to step E for units without soap.
•
FOR UNITS WITH SOAP OPTION, INSTALL THE SPACER, SOAP DISPENSER AND COVER USING THE THIRD TIE ROD (8-5/8" LONG)
AND SECOND COUPLING NUT AS SHOWN (SEE FIGURE 7). SECURE WITH ACORN NUT AND SET SCREW.
E
SECURE INFRARED MODULE COVER AND TOP COVER WITH ACORN NUT AND SET SCREW.
FOR O UNIT:
F
INSTALL 1/2" NOMINAL COPPER TUBING SUPPLY LINES (PASS THEM THROUGH HOLES IN COVER DOWN
THROUGH SUPPORT COLUMN) AND CONNECT TO STOPS USING SUITABLE FITTINGS.
Bradley Corporation • 215-1187 Rev. N; EN 06-915B
UNIT WITH "A" DRAIN AND I.R. MODULE
SHOWN, ALSO AVAILABLE WITH "O" DRAIN
SOAP
DISPENSER
COUPLING
NUT
COUPLING
NUT
TIE ROD
(STD.) 21-5/8"
(JUV.) 18-1/8"
SUPPORT TUBE
(STD.) S57-005
(JUV.) S57-006
Figure 7
TDB3108, WF3208 Terreon
TOP COVER
8-5/8"
TIE ROD
SPACER
MODULE
COVER
4-1/4"
TIE ROD
I.R. MODULE
ASSEMBLY
S50-344
TIE BAR
SPRAYHEAD
S05-054
4/6/2007
® 54" Circular
13