Adjusting The Car Seat; Adjusting The Base Of The Car Seat; Adjusting The Height Of Headrest And Straps - 5-Point Harness; Adjusting The Headrest (Group 2/3) - Foppapedretti RE-KLINO FIX Manual De Instrucciones

• ENGLISH •
4. CAR SEAT ADJUSTMENTS
4.1 Adjust the position of the seat
The car seat can be reclined to different positions, for use in various groups.
Press the adjustment lever located under the front of the car seat and, holding it down,
pull or push the seat forwards or backwards (1-A). Release the lever in the required
position and listen for the "click" to ensure that the seat is locked correctly in place.
4.2 Adjusting the height of headrest and straps - 5-point harness system (group 1)
Adjust the headrest and straps, pulling the adjustment lever located behind the headrest.
Raise or lower the headrest based on the child's height. A correctly adjusted headrest on
the car seat guarantees the best protection for your child.
Ensure that the "chest belts" are adjusted correctly and slightly higher than the child's
shoulders (4-B).
ATTENTION! Shoulder belts must not be adjusted below the level of the child's shoulders
and/or at the level of his/her ears.
Adjusting the chest belts
1. Press button (A) and pull the straps (chest belts) by grasping them from the bottom,
under the protective chest padding, to loosen them ( 4-C).
IMPORTANT: Do not pull the straps by the protective chest padding.
2. Pull the chest belt adjustment tension device on the back of the seat and move it up or
down to make the adjustment (4-D).
3. The tension adjusting device must be adjusted based on the height of the child's
shoulders in the position best suited for the child's build ( 4-E).
When the adjustment has been made, release the tension adjustment lever and ensure it
is locked correctly in place.

Adjusting the headrest (group 2/3)

A correctly adjusted headrest ensures that the vehicle's diagonal belt is in the correct
position to ensure optimal protection for the child.
The headrest must be adjusted so that two fingers can fit between the headrest and your
child's shoulders.
Adjust the headrest based on your child's build:
Press the headrest adjustment lever located on the back ( 4-F)
Raise or lower the headrest based on your child's build (4-G). Release the lever to lock it in
the required position. Ensure it is correctly locked in place.
Place your child on the seat and ensure that the adjustments have been made correctly (4-
H). Repeat these steps if necessary.
5-point belt adjustment (use for group 1)
1. Press the strap adjustment button A and, at the same time, pull the straps (chest belts)
grasping them from below, under the protective chest padding, to slacken them (5-A).
RE-KLINO FIX 26