Adjusting The Car Seat; Extending Fix Brackets; Adjusting The Headrest; Adjusting The Side Wings - Foppapedretti SKILL i-Size Manual De Instrucciones

ADJUSTING THE CAR SEAT

1. Extending FIX brackets

Pull the FIX bracket adjustment lever to extend the brackets (1A).
As shown in the figure, to retract the FIX connectors, pull the handle, at the same time
using your other hand to push the connectors towards the base, in the direction of the
arrow (1B).

2. ADJUSTING THE HEADREST

A correctly adjusted headrest ensures that the diagonal seat belt section is optimally
positioned, and gives your child the optimal protection.
The headrest must be adjusted so that there is a space two fingers wide between the
headrest and your child's shoulders.
To adjuste the height of the headrest to fit your child:
1. Reach into the adjustment handle on the back of the headrest and pull it upwards.
This unlocks the headrest.
2. Adjust the headrest to the desired height. The headrest will lock in the new position
as soon as the handle is released.
3. Position the car seat on the vehicle seat. Place the child in the car seat and check the
height of the headrest. Adjust the headrest until it is at the desired height.

3. ADJUSTING THE SIDE WINGS

Pull and hold the side wing adjustment lever, then extend or retract the side wing to
suit the child's size. Release the lever and check that the side wing is locked in the new
position. Repeat on the opposite wing.

4. ADJUSTING SEAT INCLINATION

Push the button and simultaneously adjust seat inclination to the new position. Release
the button, a "click" will indicate that it is locked in the new position. It is recommended
to adjust the inclination before securing the child with the 3-point seat belt.
5. INSTALLATION WITH 3-POINT SAFETY BELT IN COMBINATION WITH FIX
CONNECTORS
Please read the instructions on the use of child restraint systems described in your
vehicle owner's manual. Find the ISOFIX anchorage points in the vehicle seat.
Tips: the ISOFIX anchorage points are located between the surface and the backrest
of the vehicle seat.
Insert two Smart Fix guides to the ISOFIX lower anchorages respectively (5A) FIX guides
make it easier to install using the Smart Fix connectors and prevent damage to the
upholstery.
1. Remove the vehicle seat headrest if it prevents you from adjusting the car seat
headrest to the desired height (5B, 5C).
2. Press lever "A" to extend the FIX connectors. Release the lever (5D).
• ENGLISH •
USE IN THE VEHICLE
26