VQ OrthoCare Avid IF2 Manual Para El Paciente Y Para El Médic página 16

6. The app will send you an e-mail to confirm your sign-
up. Open the e-mail, click on the link to verify your
e-mail and your set up is complete (Figure C).
If you do not verify your e-mail address, the app will not
let you sign in again (Figure D).
7. Keep the app open and it will connect to the device
overnight. The app will NOT disrupt your treatment and
will NOT shut the device off to upload information.
8. If your device has not uploaded information in a week
or more, you will get a message reminding you to
open you app again to update information. To upload
your data, press "Send Data." This will take you to the
Bluetooth screen. Follow the instructions below. To
start a treatment instead, press "Skip" (Figure E).
To manually connect to the the app:
Turn on your Avid IF2 Device and go to Settings .
1.
Choose Bluetooth. Make sure Bluetooth is enabled.
2. Open the app on your phone. It should connect
automatically. If not, press "Connect" next to your
device. After upload, press the two plugs at the top to
disconnect (Figure F).
3. If you are already connected to the app and want to
refresh your data, press "Get Data" at the bottom of the
Device Information Screen.
14 | Avid IF2 Patient Manual
Figure C
Figure D
Figure E
Figure F