Össur LP VARI-FLEX VLPE Serie Instrucciones Para El Uso página 7

HEEL DIVIDER
The heel divider should be placed in the posterior of the splitted heel
part. To secure its position a drop of instant adhesive can be used on one
side.
FLEX-FOOT SOCK
The toe end of the sock is divided by a thread and fits within the toe split.
Upon fitting the sock, hold the top of the toe thread and slide the sock
into the toe split. The thread of the sock should rest on top of foot
module and not underneath the toe split. The sock should be loose from
the heel area and secured proximally with the cable tie provided.
SHOE HORN
When removing and installing the cover use shoehorn to avoid damage
to foot or cover (Figure 7 & 8).
Note: Tampering with the pyramid attachment bolts will void the
warranty of the product
WEATHERPROOF
A weatherproof device allows use in a wet and/or humid environment
but does not allow submersion. Fresh water splashing against the
enclosure from any direction shall have no harmful effect. Dry thoroughly
after contact with fresh water. Fresh water: Includes tap water. Excludes
salt and chlorinated water.
LIABILITY
The manufacturer recommends using the device only under the specified
conditions and for the intended purposes. The device must be
maintained according to the instructions for use. The manufacturer is
not liable for damage caused by component combinations that were not
authorized by the manufacturer.
COMPLIANCE
This component has been tested according to ISO 10328 standard to two
million load cycles. Depending on the amputee's activity this
corresponds to a duration of use of two to three years. We recommend
carrying out regular yearly safety checks.
ISO
*) Body mass limit not to be exceeded!
For speci c conditions and limitations of use see
manufacturer's written instructions on intended use!
In the standard mentioned, test levels (P) are assigned to a certain
maximal body masses (m in kg). In some cases, which are marked with,
no test level is assigned to the product related maximal body mass. In
these cases, the test loads have been adapted adequately on the basis of
the specified load level.
- "P" - "m"kg *)
7