Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open the rear lift gate of the
vehicle and remove the plastic
threshold (Fig. 1). Remove the
two cargo net anchor hooks from
both the left (driver's) side and
right (passenger) side paneling.
Carefully pull back the trim
paneling from each side to expose
the vehicles taillight wiring harness
connectors; they will be similar in
appearance to those on the T-Connector
(Fig. 2).
Note: If the vehicle is equipped
with an automatic lift gate,
remove the plastic trim covering
from the lift assembly on the
left (driver's) side to expose the
vehicles taillight wiring harness
connectors (Fig.3).
3. Starting on the left (driver's) side of
the vehicle, separate the grey connectors,
taking care not to damage the locking tabs. Insert
the T-Connector ends with the Yellow wires between these
Fig. 1
Fig. 2
Fig. 3
Publicidad
