Using Subwoofer Output; Adjusting Subwoofer Settings - Pioneer DVH-P7000R Manual De Operación

Section
Audio Adjustments
09

Using subwoofer output

This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to the rear output, first,
switch the rear output setting to subwoofer,
then turn the subwoofer output on. For more
details, see Setting the rear output and
subwoofer controller on page 82.
1 Press to select
A
When the subwoofer controller setting is
, you cannot select
Control:EXT
until appears in the display.
Sub-W1
• Pressing
AUDIO
forms the same operation.
2 Press E to turn subwoofer output on.
appears in the display.
Sub-W1 Normal
Subwoofer output is now on.
• You can turn off subwoofer output by pressing
e.
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
3 Press 1 or ¡ to select the phase of
subwoofer output.
Press 1 to select reverse phase and
appears in the display. Press ¡ to select nor-
mal phase and
Normal
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
Downloaded from Caradio-Manual.com Manuals
66 En
All manuals and user guides at all-guides.com
.
Sub-W1
S.W
. Press
Sub-W1
on the head unit also per-
Rev.
appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press to select the
A
When the subwoofer output is on, you can
select the
Sub-W2
appears in the display.
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as
A
(Hz).
• Pressing
AUDIO
forms the same operation.
2 Press 1 or ¡ to select cut-off
frequency.
Press 1 and
50
and (Hz) is displayed. Only frequencies
125
lower than those in the selected range are out-
put from the subwoofer.
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
3 Press E or e to adjust the output level
of the subwoofer.
Each press of E or e increases or decreases
the level of the subwoofer (e.g.,
Press E or e until you see the desired value
displayed.
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
.
Sub-W2
. Press until
A Sub-W2 80
(Hz) or
50
on the head unit also per-
(Hz) is displayed. Press ¡
to ).
+6 –6
(Hz)
125