Pivoting The Pole-Mounted Pruner; Putting On The Carrying Harness; Sliding The Carrying Eye - Parkside PGKGA 40-Li B2 Traducción Del Manual De Instrucciones Original

GB IE
3. By simultaneously exerting pressure on
the lock lever (45), you will loosen the
fi xation of the cutter bar.
4. The safety blade beam can now be
swivelled out. Use the stop stages and
allow the stop lever (45) to click back
in. The device has 7 possible working
positions. There is a further position for
space-saving storage.
5. Then, release the safety lever (44)
again and ensure that it latches back
into its initial position.
Pivoting the pole-
mounted pruner
1. Pull the lock (46) outward and turn it
90°.
2. Hold the pole-mounted pruner at the
protective transport (9) and turn it to
the desired position.
There are fi ve possible positions.
3. Fix the pole-mounted pruner by pulling
the lock (46) outward and turning it
90° back to the original position.
Putting on the carrying
harness
The body protection (20) on
the carrying harness must
be placed between the body
and the device.
Always wear the carrying
harness when working with
the 3-tooth blade! Always
turn the device off before
taking off the carrying har-
ness. Accident hazard.
Generally, we recommend using the
carrying harness whenever using
the device.
60
The harness is equipped with
a quick-release lock (47).
Squeezing the quick-release
lock (47) together releases
the device quickly from the
harness in a dangerous situ-
ation.
1. Wear the carrying harness (19) like a
backpack. The clip must be situated on
the chest.
2. Adjust the strap length so that the body
protection (20) is level with the hip.
3. Open the quick-release lock (47).
4. Push open the snap hook.
5. Attach the snap hook to the eyelet (6)
on the tube shaft of the device.
6. Clip the quick-release lock (47) back
together with the device.
Place the body protection (20) on
your hip between your body and
the device.
While wearing the carrying harness,
ensure that the pad is placed on your
shoulders to increase comfort.

Sliding the carrying eye

Select the appropriate position for the car-
rying harness eyelet according to whether
you are using a spool/3-toothed blade or
pruner/hedge trimmer.
You can slide the carrying eye (
better distribute the weight of the device.
1. Loosen the screw (48) on the eyelet
(6) for the carrying harness, using the
hexagon socket wrench (21) from the
storage ( 31).
A
2. Slide the eyelet (6) to the appropriate
position.
3. Tighten the screw (48) again.
6) to
A