Assemble The 3-Tooth Blade; Mount The Spool; Extend The Thread - Parkside PGKGA 40-Li B2 Traducción Del Manual De Instrucciones Original

For the trimmer/3-tooth blade operation:
Without touching it by hand, the device
attached to the harness should

allow the spool to rest lightly on the
ground

balance the blade approximately 20
cm above the ground.
1. Loosen the screw (48) on the carrying
harness eye with the hexagon socket
wrench (21) and tighten it slightly.
2. Depending on the cutting tool, balance
the tool according to the criteria men-
tioned above by moving the eyelet (6)
along the tube shaft (4).
3. Tighten the screw (48) when the device
is in the desired position.
Assemble the 3-tooth
blade
Whenever you use the
3-tooth blade, the protective
cover without extension must
be used. (See Chapter: "Re-
moving/mounting the protec-
tive cover extension")
1. Remove the rechargeable batteries.
2. Place the device on the ground in a
stable position.
3. Block the mounting spindle (52) using
the hexagon socket wrench (22) as de-
picted.
4. Place the 3-toothed blade onto the
mounting spindle (52). The blade can
be used on both sides.
5. Fasten the blade using the thinner
washer (53), conical spring washer
(54) and nut (55).
Insert the nut (55) into the conical
spring washer (54) as shown.
Use the assembly key (23) to secure it.
6. Remove the hexagon socket wrench
(22)!
Dismantling is carried out in reverse
order.

Mount the spool

The protective cover must be
mounted with the extension
when using the thread spool.
(See Chapter: "Removing/
mounting the protective
cover extension")
Do not replace the non-me-
tallic fi laments of the spool
end with metallic fi laments!
Risk of injury!
1. Remove the rechargeable batteries.
2. Place the device on the ground in a
stable position.
3. Block the mounting spindle (52) using
the hexagon socket wrench (22) as de-
picted.
4. Place the thin washer (53) on the
mounting spindle (52).
5. Screw the spool cap (17) anticlock-
wise back onto the mounting spindle
(52).
Dismantling is carried out in reverse
order.

Extend the thread

Your device is equipped with a double-
string activated touch control, i.e. the two
strings are extended when you tap the
cutting head on the ground.
GB IE
61