Connections; Rear Panel - Pioneer DJM-900NXS Manual De Instrucciones

Connections

Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections.
Refer to the operating instructions for the component to be connected.
Connect the power cord after all the connections between devices have been completed.
Be sure to use the included power cord.

Rear panel

1
OFF POWER
ON
AC IN
i
1 POWER button (page 13)
Turns this unit's power on and off.
2 RETURN terminals (page 7)
Connect to the output terminal of an external effector. When the [L (MONO)]
channel only is connected, the [L (MONO)] channel input is simultaneously
input to the [R] channel.
3 PHONO terminals (page 7)
Connect to a phono level (MM cartridge) output device. Do not input line level
signals.
To connect a device to the [PHONO] terminals, remove the short-circuit pin plug
inserted in the terminals.
Insert this short-circuit pin plug into the [PHONO] terminals when nothing is
connected to them to cut external noise.
4 CD/ LINE terminals (page 7)
Connect to a DJ player or a line level output component.
5 SIGNAL GND terminal (page 7)
Connect an analog player's ground wire here. This helps reduce noise when the
analog player is connected.
6 LINE terminals (page 7)
Connect to a cassette deck or a line level output component.
7 MIC2 terminal (page 7)
Connect a microphone here.
8 MIDI OUT terminal (page 7)
Connect this to the MIDI IN terminal on an external MIDI sequencer.
9 Kensington security slot
a DIGITAL IN terminal (page 7)
Connect these to the digital coaxial output terminals on DJ players, etc. The
sound may be momentarily interrupted when the output signal sampling fre-
quency is switched.
b DIGITAL MASTER OUT terminals (page 7)
Outputs the master channel audio signals.
c LINK terminal (page 7)
Connect these to the LINK terminals on Pioneer DJ players or the LAN ports of
computers on which rekordbox is installed (PRO DJ LINK).
To connect multiple devices, use a switching hub (commercially available).
Use a 100Base-TX-compatible switching hub. Some switching hubs may not
operate properly.
6
En
2 3 4 5
CH 4
PHONO CD/ LINE
L
RETURN
R L
(MONO)
SIGNAL GND
R
MASTER1
SEND
R
R L
(MONO)
1 GND
h g
6 4 6 4
CH 3 CH 2
LINE CD/ LINE LINE CD/ LINE
L L
SIGNAL GND
R R
MASTER2 REC OUT BOOTH
L L L TRS
R
R R
2 HOT
3 COLD
f e d
d BOOTH terminals (page 7)
Output terminals for a booth monitor, compatible with balanced or unbalanced
output for a TRS connector.
e REC OUT terminals (page 7)
This is an output terminal for recording.
f MASTER2 terminals (page 7)
Connect to a power amplifier, etc.
g MASTER1 terminals (page 7)
Connect to a power amplifier, etc.
h SEND terminals (page 7)
Connect to the input terminal of an external effector. When the [L (MONO)]
channel only is connected, a monaural audio signal is output.
i AC IN
Connect to a power outlet using the included power cord. Wait until all connec-
tions between the equipment are completed before connecting the power cord.
Be sure to use the included power cord.
WARNING
The short-circuit pin plugs out of the reach of children and infants. If accidentally
swallowed, contact a doctor immediately.
5 3 4 7
CH 1
PHONO CD/ LINE
L
MIC2
R
CH2
L
MASTER
LINK
OUT
CH4
c b
8 9
MIDI OUT
DIGITAL
CH1
IN
CH3
a