Pressure Setting - Goetze 2140 Manual De Instrucciones

7

Pressure setting

Maintenance intervals depend on the operating conditions and must be determined by the
operator. If deviations from the normal condition are detected during maintenance (e.g.
leakages, incorrect pressure control, noises, etc.), the shut-off valves must be replaced im-
mediately or professionally repaired, in order to ensure continued safe operation.
Repairs to shut-off valves must be performed only by Goetze KG Armaturen or by authorised
specialist workshops, using only genuine spare parts. Makeshift repairs of any kind are not
permitted!
Fault
Leak from the
spindle
Leak between
upper section and
housing
Leak from the seat
Valve does not
open / close
Assembly and maintenance instructions - 2140 / 2180
Possible cause
•
Spindle seal leaky
•
Gland nut loose
• Gland packing defective
• Fitting / surface of spindle damaged
• Valve upper section loose
•
Seal damaged
•
Foreign bodies between the disc
and seat
•
Seat damaged
•
Cone assembly seal damaged
• Thread stuck, damaged
• Handwheel defective, damaged
Solution
Remove the screw (pos. 8)

Remove the handwheel (pos. 9)

Undo the lock nut (pos. 10)

Retighten the gland nut (pos. 11)

Tighten the lock nut (pos. 10)

Detach the handwheel (pos. 9)

 Tighten the screw (pos. 8)
Replace the gland packing

Replace upper section

Tighten the screws to the specified

tightening torque
Replace the seal

Remove foreign bodies, flush and

clean system
Replace housing

Replace seal

(together with cone, if necessary)
Replace housing

Replace spindle + handwheel

www.goetze-armaturen.de