Fitting/Removing Brake Clamp; Fitting/Removing Steering Wheel Arrester; Turntables And Sliding Bases - Bosch FWA 9000 Manual Del Usuario

3.5

Fitting/removing brake clamp

Abb. 6: Fitting the brake clamp
i
Ensure proper attachment to prevent damage to the
seat and steering wheel. Place a cloth underneath if
necessary.
i
After run-out compensation, fit the brake clamp for
further measurements.
3.6 Fitting/removing steering wheel
arrester
The steering wheel arrester fixes the steering wheel in
position and blocks the wheels
1. Place the steering wheel arrester on the seat and
press the plate into the seat.
2. Slide the arms upwards against the steering wheel.
3. Release the plate so that pressure is exerted on the
steering wheel by way of the seat cushion.
4. Remove in the reverse order of fitting.
Abb. 7: Steering wheel arrester
i
Ensure proper attachment to prevent damage to the
seat and steering wheel. Place a cloth underneath if
necessary.
Robert Bosch GmbH
Product description | FWA 9000 | 21 | en
3.7

Turntables and sliding bases

Abb. 8: Turntable
1 Securing pins with securing cable
2 Turntable
3 Panel socket
!
Turntables and sliding bases must be secured when
driving on and off and during initial measurement.
Component Securing against
Turntables and sli- Movement in
R Direction of travel
ding bases
R Opposite direction
R Rotation
Turntable
R Longitudinal move-
Sliding plates
ment
R Transverse move-
ment
7
6
5
4
Abb. 9: Securing of turntables and sliding bases
1 Turntable
2 Turntable securing pins (2 x)
3 Sliding plate fixing pins (2 x)
4 Sliding bases
5 Fillers in front of turntable
6 Turntable
7 Fillers behind turntable
Secured by
R Attachment to
runway
R Fillers
Securing pins
Fixing pin
1
2
3
|
1 690 906 002 2017-07-04